Jual Hobbywing xrotor nano f4 flight controller with OSD for micro drone
Firmware Version: OMNIBUSF4SD
MCU: STM32 F405
Accelerometer & Gyro: MPU6000
- With onboard OSD, controlled by F4 MCU
BEC: 5V @ 1A
Mounting Hole: 20x20mm
- Voltage Monitor: Supported
- Current Monitor: Supported
- External Buzzer: Supported
- LED Controll: Supported
- USB Port: MicroUSB
- FC Programming: Suppored
- Programming Via: Betaflight / Cleanflight-Configurator
Compatibel with ( Modes): PWM, Oneshot125, Oneshot42, Multishot, DShot150, DShot300
DShot600, DShot1200 and Proshot1000
Compatible with ( Transmitter): PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL
Application: 130mm & below FPVs
-Onboard OSD microchip which supports the DMA mode allows users to adjust its parameters via
the Betaflight software. (Note: the OSD is controlled by the F4 MCU.)
-The FC which supports Betaflight firmware & allows parameter adjustment via Betaflight software
is more applicable to FPV race.
-TF-card which can record and save more flightack box data allows users to adjust the setup of
their aircraft easily.
- Compatible with various receivers like SBUS, SUMH, SUMD, SPEKTRUM1024/2048, XBUS, PPM
- LED strip signal output port allows users to adjust the color & flash mode of the LED strip via the FC.
- Volt/Amp monitoring port allows users to check the battery voltage ( VBAT+ port ) and current
( CRT port ) (extra current meter is needed).
- Buzzer output port allows users to connect external buzzer(s) to the FC for warning or informing
the flight status of the aircraft.
- Micro USB port allows users to connect the FC to a PC to flash firmware and adjust parameters.
1x Hobbywing XRotor Nano F4 Flight Controller